How do I install the Printer?

Zebra Printer Set up Instructions

  1. Plug the printer into the router/Ethernet outlet where it will sit.
  2. Hold down the button on top of the printer until it flashes once and let go.
  3. A list of information will print, find the IP Address listed on the first page under the heading Network Configuration [This will be a set of numbers similar to 010.100.000.001].
  4. Find a computer that uses the same router, open a web browser (i.e. Chrome, Firefox, etc), and enter the IP Address without the leading zeros in the address bar [Using the earlier example it would be 10.100.0.1].
  5. When the Zebra Printer page loads, click on “Print Server Settings” at the bottom of the page, then click on “Print Server” underneath Status and Configuration, and enter the Username “admin” and Password “1234″.
  6. Click on “TCP/IP Configuration” and change the IP Address you found earlier, you will want to add 30 to the last number to prevent other devices from potentially taking the address [Using the earlier example, change it to 10.100.0.31].
  7. You will want to make note of the new IP Address, this will be entered on the iPad. Turn the printer off and then back on in order to allow the settings to fully upload.
  8. Log into the Free Church Kiosk app, click on the Settings Gear at the top-right, and re-enter your login information.
  9. Click on the “Print Setting” button at the bottom-right.
  10. Enter the new IP Address from Step 6 in the box that appears and press OK.
  11. Press “Test Print” on the iPad, if everything is correctly configured the printer will print a label with the words “Test Print”.